ST-LINK/V2(CN Version) ST MCU Microcontroller STM8 STM32 JTAG SWD SWIM In-circuit Debugger Programmer Emulator

ST-LINK/V2(CN Version) ST MCU Microcontroller STM8 STM32 JTAG SWD SWIM In-circuit Debugger Programmer Emulator

View More

25,35

(15 customer reviews)

Attualmente disponibile su ordinazione con consegna prevista entro 60 giorni circa dall'acquisto.

QuantitàPrezzo Unitario
12 - 49 22,82
50 - 99 20,28
100 + 17,75

Product Description

ST-LINK/V2(CN Version) ST MCU Microcontroller STM8 STM32 JTAG SWD SWIM In-circuit Debugger Programmer Emulator

 
The ST-LINK/V2 is an in-circuit debugger and programmer for the STM8 and STM32 microcontroller families. The single wire interface module (SWIM) and JTAG/serial wire debugging (SWD) interfaces are used to communicate with any STM8 or STM32 microcontroller located on an application board. 
STM8 applications use the USB full speed interface to communicate with STMicroelectronic’s ST Visual Develop (STVD) or ST Visual Program (STVP) software. 
STM32 applications use the USB full speed interface to communicate with Atollic, IAR, Keil or TASKING integrated development environments. 

Features 
5 V power supplied by a USB connector 
USB 2.0 full speed compatible interface 
USB standard A to mini B cable 
SWIM specific features 
*1.65 V to 5.5 V application voltage supported on SWIM interface 
*SWIM low-speed and high-speed modes supported 
*SWIM programming speed rate: 9.7 Kbytes/s in low speed and 12.8 Kbytes/s in high speed 
*SWIM cable for connection to the application via an ERNI standard vertical (ref: 284697 or 214017) or horizontal (ref: 214012) connector 
*SWIM cable for connection to the application via a pin header or a 2.54 mm pitch connector 
– JTAG specific features 
*1.65 V to 3.6 V application voltage supported on the JTAG interface and 5 V tolerant inputs 
*JTAG cable for connection to a standard JTAG 20-pin pitch 2.54 mm connector 
Direct firmware update feature supported (DFU) 
Status LED which blinks during communication with the PC 
Operating temperature 0 to 50 °C 

While connecting the ST-LINK/V2 to the computer through USB interface, the USB driver is required and should be installed correctly first.

Package Contains
ST-LINK/V2*1
USB type A to Mini-B cable*1
20-pin JTAG/SWD flat ribbon*1
4-pin SWIM cable*1
4-pin SWIM custom connector cable*1

 

Abbiamo disponibili datasheet di tutti i componenti, qualora non fosse presente nella scheda download del prodotto inviaci un messaggio dal modulo contattaci e lo pubblicheremo il prima possibile nel sito.

Facebooktwitterredditpinterestlinkedinmail

There are no reviews yet.

Be the first to review “ST-LINK/V2(CN Version) ST MCU Microcontroller STM8 STM32 JTAG SWD SWIM In-circuit Debugger Programmer Emulator”