PH Sensor For Arduino

PH Sensor For Arduino

More details

ARD001981
New product

27,15 €

Immediately available

- +

Add to compare

Free Google QRcode module

 
More info

PH Sensor For Arduino

Introduction

Need to measure water quality and other parameters but haven't got any low cost pH meter? Find it difficult to use with Arduino? Here comes an analog pH meter, specially designed for Arduino controllers and has built-in simple, convenient and practical connection and features. It has an LED which works as the Power Indicator, a BNC connector and PH2.0 sensor interface. To use it, just connect the pH sensor with BNC connector, and plug the PH2.0 interface into the analog input port of any Arduino controller. If pre-programmed, you will get the pH value easily. Version 1.1 is based on the improvement of Version 1.0. We changed the charge-pump chip with higher accuracy.

Applications

  • Water quality testing
  • Aquaculture

Specification

  • Module Power : 5.00V
  • Module Size : 43mm×32mmx20mm
  • Measuring Range:0-14PH
  • Measuring Temperature :0-60 ℃
  • Accuracy : ± 0.1pH (25 ℃)
  • Response Time : ≤ 1min
  • pH Sensor with BNC Connector
  • PH2.0 Interface ( 3 foot patch )
  • Gain Adjustment Potentiometer
  • Power Indicator LED
  • Cable Length from sensor to BNC connector:660mm

 

Abbiamo disponibili datasheet di tutti i componenti, qualora non fosse presente nella scheda download del prodotto inviaci un messaggio dal modulo contattaci e lo pubblicheremo il prima possibile nel nostro sito.

 
Download

Ph sensor

Ph sensor manual and sample

Download (0)

Write a review

Write a review

 
Comments(0)
12/8/2018
Feedback ricevuto nel nostro negozio eBay http://stores.ebay.it/circuitointegrato

Tutto ok

  • Was this comment useful to you?
  • (0) (0)

8 other products in the same category:

Compare 0

No products

To be determined Shipping
0,00 € Total

Check out